Cal Spa ELE09100040 Circuit Board C11G0R1B

Cal Spa ELE09100040 Circuit Board C11G0R1B
  • Manufactured by: Cal Spa
  • Part Number: ELE09100040
  • Chip Number: C11G0R1B


Item Number: 22-5972

  • Description
  • Details
  • Reviews
Please read entire page before placing an order.

This new OEM circuit board is for replacing Cal Spa ELE09100040 circuit boards having a C11G0R1B chip number.
The ELE09100040 part number may also be shown as CALELE09100040, 09100040.
Please Note: The numbers on the new circuit board you receive may be different and the components may look slightly different but it will still connect the same and it is a fully compatible OEM replacement .
Cross Reference Verification
Tip: Locate the chip number on the circuit board you are replacing.
Tip: The whole chip number is on a sticker located on the circuit board (not the box).
Tip: The chip number sticker usually has two lines of text and the top line is the whole chip number (the bottom line is not needed).
Tip: See image above for an example of a chip number sticker and where they're typically found on the circuit board (click the image to enlarge it).

Verify the chip number on the circuit board being replaced placed is in this list.

Chip Numbers:
  • C11G0R1A
  • C11G0R1B
  • CS11G0R1A
  • CS11G0R1B
Additional Cross Ref., Compatibility & Installation
If a wiring diagram is shipped with this new circuit board (or emailed) then it shall override your existing wiring diagram.

Otherwise, set wires and/or jumper pins and/or dip switches on the new circuit board to match how they are on the existing circuit board (assuming the old circuit board is already set correctly as per the original wiring diagram on the existing control box).
System Control Box Serial Numbers
Tip: The system control box is usually located below the hot tub and the circuit board mounts inside of it.

Please note: System control box serial numbers cannot identify a circuit board.
Please note: Do not use this section for confirmation of making the correct purchase.

The Cal Spa ELE09100040 C11G0R1B circuit board can be found in the following hot tub system control boxes (but not limited to).

System Control Box Serial Numbers:
  • ELE09020010
Tip: When replacing a hot tub circuit board, testing the heater and replacing it (if bad), is recommended before installing or applying voltage on a new circuit board.
Note: A continuity test is not a sufficient heater test. Contact us by phone for more details on testing a heater.

Tip: Burned circuit boards or burned heater relays are often due to a loose electrical connection or a bad heater or both.
If all connections are tight and if the heater is good then the heater relays are probably old and worn out.
If a burned relay was powering a pump and all electrical connections are tight then the relay is probably old and worn out or the pump might be bad or going bad or all three.
Replacing the heater and/or pump with a new one is recommended if any of those scenarios apply.

Unsure of what something on this page means?

Please contact us so we can better assist you.

  • Manufactured by: Cal Spa
  • Part Number: ELE09100040
  • Part Number: C11G0R1B
  • Item Number: 22-5972

Be the first to write a review.  Write a Review.