T
o
p


Balboa 54000 Circuit Board SERDLXR1(x) Alt Replacement 2

Balboa 54000 Circuit Board SERDLXR1(x) Alt Replacement 2
  • Manufactured by: Balboa Water Group, Inc.
  • Part Number: 54000
  • Chip Number: SERDLXR1(x)


Call for Price

Item Number: 22-6794

  • Description
  • Details
  • Reviews

The Balboa 54000 SERDLXR1(x) circuit board is discontinued but we have options.

Option 1: Scroll down to RELATED PRODUCTS for other replacement options.

Option 2: Get your circuit board repaired.  Please contact us before sending items in for repair.

Option 3: Contact us to inquire about a new retro-fit system control box replacement.

Cross Reference Verification
Serial Numbers:
  • 54000
  • BAL54000

Chip Numbers:
  • SERDLXR1A
  • SERDLXR1B
  • SERDLXR1C
  • SERDLXR1D
  • SERDLXR1E
  • SERDLXR1F
Additional Cross Ref., Compatibility & Installation
Install Setup for 7-Button control panels:
When using a 7-Button (or less) control panel, you must set the following jumpers on this replacement circuit board.
1. Jumpers J6 and J17 need to be set on one pin.
2. Jumper J10 needs to be set on both pins.
This configuration will operate Pump 1 at two speeds, Pump 2 at two speeds and an Air Blower at two speeds.

ATTENTION:
In the lower right hand corner of this replacement circuit board is a square 3 finger Triac that must have a screw down through it, a wire terminal ring with grounded wire and a backing nut.
Make sure you have it screwed in, otherwise failure to do this will cause damage to the air blower and circuit board.
Tip: When replacing a hot tub circuit board, testing the heater and replacing it (if bad), is recommended before installing or applying voltage on a new circuit board.
Note: A continuity test is not a sufficient heater test. Contact us by phone for more details on testing a heater.

Tip: Burned circuit boards or burned heater relays are often due to a loose electrical connection or a bad heater or both.
If all connections are tight and if the heater is good then the heater relays are probably old and worn out.
If a burned relay was powering a pump and all electrical connections are tight then the relay is probably old and worn out or the pump might be bad or going bad or all three.
Replacing the heater and/or pump with a new one is recommended if any of those scenarios apply.

Tip: See RELATED PRODUCTS below for more Balboa 54000 SERDLXR1(x) replacement options.

Unsure of what something on this page means?

Please contact us so we can better assist you.


  • Manufactured by: Balboa Water Group, Inc.
  • Part Number: 54000
  • Part Number: SERDLXR1(x)
  • Item Number: 22-6794


Be the first to write a review.  Write a Review.

Related Products

(Items shown here are sold separately.)