Balboa 53363 Circuit Board TS2000R1(x), Thermo Spas

ATTENTION: This replacement circuit board can ONLY be mounted in TS2000 systems with a metal control box.
Do NOT place this order if you have a plastic control box.
Instead, please give us a call for other replacement options.

ATTENTION: Configuration instructions for this alternate replacement circuit board are as follows.
*To be performed BEFORE applying electricity.
*Turn electricity OFF.:
1. Set dipswitch bank 'A' switch #2 in the ON position, set switch #12 in the ON position and all the rest of the switches in the OFF position.
2. Set dipswitch bank "B" switch #1, #2 and #3 in the ON posistion and the rest of the switches in the OFF position.
3. Set all wires on the NEW circuit board to match the wires on the OLD cicuit board.
Tip: If there is a wire on EITHER circuit board that is not on the other cicuit board, then just skip it.
4. Find the 'CFG' jumper pin on the NEW circuit board and set its black plastic sleeve on only ONE pin.
Tip: The 'CFG' jumper pin is located nearby where the sensors plug in on the NEW circuit board.

Note: After re-starting the system (give it time to boot up), test the features (I.E. pumps and speeds, etc).
If the hot tub is functioning properly, then turn the electricity OFF and set dipswitch bank 'A' switch #12 in the OFF position.

Configuration is complete and the system can be re-started again.

If the hot tub still isn't funtioning properly after following these instructions, please contact us.

Tip: The system control box is usually located below the hot tub and the circuit board mounts inside of it.

The Balboa 53363, TS2000R1(x) circuit board can be found in the following hot tub system control boxes (but not limited to).

System Control Box Serial Numbers: