Balboa 52252 Circuit Board SW100R1(x), Southwest Spas

Cross Reference Verification

Serial Numbers:

• 52252
• BAL52252

Chip Numbers:

• SW100R1A
• SW100R1B
• SW100R1C
• SW100R1D
• SW100R1E
• SW100R1F

Additional Cross Ref., Compatibility & Installation

ATTENTION: You will LOSE the SECOND speed on Pump 2 when using this replacement circuit board.
Everything else operates the same.

If you don't want to LOSE the second speed on Pump 2 then do NOT place this order.
Instead, please give us a call for another replacement option (if available).

System Control Box Serial Numbers

Tip: The system control box is usually located below the hot tub and the circuit board mounts inside of it.

The Balboa 52252, SW100R1(x) circuit board can be found in the following hot tub system control boxes (but not limited to).

System Control Box Serial Numbers:

• 52244
• 52244-01
• 52244-02
• 52244-03
• WH-SW100-CCAH

Tip: When replacing a hot tub circuit board, testing the heater and replacing it (if bad), is recommended before installing or applying voltage on a new circuit board.
Note: A continuity test is not a sufficient heater test. Contact us by phone for more details on testing a heater.

Tip: Burned circuit boards or burned heater relays are often due to a loose electrical connection or a bad heater or both.
If all connections are tight and if the heater is good then the heater relays are probably old and worn out.
If a burned relay was powering a pump and all electrical connections are tight then the relay is probably old and worn out or the pump might be bad or going bad or all three.
Replacing the heater and/or pump with a new one is recommended if any of those scenarios apply.

Tip: Items shown in RELATED PRODUCTS below have also been found in hot tub systems with Balboa 52252, SW100R1(x) circuit boards.

Unsure of what something on this page means?

Please contact us so we can better assist you.