T
o
p


Jacuzzi 2600-018 Circuit Board K286R1(x) Alt Replacement

Jacuzzi 2600-018 Circuit Board K286R1(x) Alt Replacement
  • Manufactured by: Jacuzzi, Inc.
  • Part Number: 2600-018
  • Chip Number: K286R1(x)

$360.16



Item Number: 22-4539

  • Description
  • Details
  • Reviews
Please read entire page before placing an order.

This money saving alternate replacement circuit board is for replacing Jacuzzi 2600-018 circuit boards having a K286R1(x) chip number.
The 2600-018 part number may also be shown as 2600018.

Tip: The "(x)" shown above is shorthand for a range of last letters on K286R1 chip numbers this alternate replacement circuit board can replace.

Please note: A list of chip numbers this alternate replacement circuit board can replace is specified in the CROSS REFERENCE VERIFICATION section below.

Please note: This alternate replacement circuit board is made by the same manufacturer, it is brand new, it is compatible with your system (unless specified otherwise in the ADDITIONAL CROSS REF., COMPATIBILITY & INSTALLATION section below), it has the same quality and durability.

Please note: This alternate repalcement circuit board will have different numbers.
Cross Reference Verification
Tip: Locate the chip number on the circuit board you are replacing.
Tip: The whole chip number is on a sticker located on the circuit board (not the box).
Tip: The chip number sticker usually has two lines of text and the top line is the whole chip number (the bottom line is not needed).
Tip: See image above for an example of a chip number sticker and where they're typically found on the circuit board (click the image to enlarge it).

Verify the chip number on the circuit board being replaced placed is in this list.

Chip Numbers:
  • K286R1A
  • K286R1B
  • K286R1C
  • K286R1D
  • K286R1E
  • K286R1F
Additional Cross Ref., Compatibility & Installation
ATTENTION:
If your system has a circulator pump, then Pump 1 and Pump 2 will one operate at one speed.

If your system does not have a circulator pump then both jet pumps can operate on two speeds.
Tip: When replacing a hot tub circuit board, testing the heater and replacing it (if bad), is recommended before installing or applying voltage on a new circuit board.
Note: A continuity test is not a sufficient heater test. Contact us by phone for more details on testing a heater.

Tip: Burned circuit boards or burned heater relays are often due to a loose electrical connection or a bad heater or both.
If all connections are tight and if the heater is good then the heater relays are probably old and worn out.
If a burned relay was powering a pump and all electrical connections are tight then the relay is probably old and worn out or the pump might be bad or going bad or all three.
Replacing the heater and/or pump with a new one is recommended if any of those scenarios apply.

Unsure of what something on this page means?

Please contact us so we can better assist you.


  • Manufactured by: Jacuzzi, Inc.
  • Part Number: 2600-018
  • Part Number: K286R1(x)
  • Item Number: 22-4539


Be the first to write a review.  Write a Review.