Balboa 50833 Circuit Board SS23DR1(x) Alt Replacement, Conway, Emerald

Cross Reference Verification

Serial Numbers:

• 50833
• BAL50833

Chip Numbers:

• SS23DR1A
• SS23DR1B
• SS23DR1C
• SS23DR1D
• SS23DR1E
• SS23DR1F

Additional Cross Ref., Compatibility & Installation

Changes in functionality:
1. The original circuit board has two filter cycles which are 6 hour and 12 hour cycles.
- This new alternate replacement circuit board has two filter cycles which are 2 hour and 5 hour cycles.

2. With the original circuit board, choosing a filter cycle is done using the topside control panel buttons.
- With the new alternate replacement circuit board, choosing a filter cycle is done by setting a jummper pin sleve on the circuit board (jumper pin sleeves are provided).

Tip: When replacing a hot tub circuit board, testing the heater and replacing it (if bad), is recommended before installing or applying voltage on a new circuit board.
Note: A continuity test is not a sufficient heater test. Contact us by phone for more details on testing a heater.

Tip: Burned circuit boards or burned heater relays are often due to a loose electrical connection or a bad heater or both.
If all connections are tight and if the heater is good then the heater relays are probably old and worn out.
If a burned relay was powering a pump and all electrical connections are tight then the relay is probably old and worn out or the pump might be bad or going bad or all three.
Replacing the heater and/or pump with a new one is recommended if any of those scenarios apply.

Unsure of what something on this page means?

Please contact us so we can better assist you.